CO (Carbon Dioxide) Measuring solution for Car Parking
Particularly underground parking lots require ventilation to get rid of dangerous pollutants and to have smoke extraction devices in case of an emergency fire.
​
Parking lot managers must consequently strike a balance between these needs and operating expenses. Natural ventilation is a possible alternative, but it's not always the best choice because it doesn't allow for smoke clearing.
​
Induction or impulse fans are used in mechanical ventilation to move the air and push it into evacuation ducts.
​
Get the best CO (Carbon Dioxide) Measuring solutions from Massive Technologies
-
CO/NO2 car park Monitoring / Ventilation fan control (Save Energy For Next Generation)
-
Enhanced CO gas Radicals detection for Very Early Smoke and Fire Alarm Systems
CO Gas Sensors / Transmitters ( CO and CO + Enhanced gas radicals with Early Fire and Smoke Detection)
-
Measuring Range : 0-300PPM (also available in 0-200 PPM, 500 PPM).
-
Digital measurement value processing incl. temperature compensation.
-
Low zero point drift, minimal false alarms
-
Long sensor life time with regular maintenance
-
Hardware & software according to SIL2 compliant development process
-
4 – 20 mA (or 2-10 V) analog output
-
Special mode, fault etc.
-
Reverse polarity protected, overload and short-circuit protected
-
Available in IP 65, 54 and 44 polycarbonate glass fibre reinforced acc. EN 60529/DIN VDE0470-1
-
Impact resistant for tough industrial environments IK08 acc. DIN EN 5012/ VDE 0470
-
Fire retardant 5VA nach UL 50/ UL 746C, V-2 acc. UL 94, 960o C acc. VDE 0471 / EN 6069
Also Available for Gas Types:
-
Carbon Monoxide ( CO) / Nitrogen Dioxide ( NO2)
-
Refrigerants like; R134a, R410a, R123, CO2, Ammonia etc.
-
Explosive Gases like; Methane, Propane, LPG, Hydrogen, LNG & CNG etc.
-
Coal Seam Methane Gas, VEFSA ( Very Early Fire Detection and Smoke Alarm for spontaneous combustion of coal
-
IAQ (CO2 / VOC) for fresh air fan intake fan control